Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuale Utente Scaricare il pdf (Pagina 81)

Configuring the UDC Module’s Registers

3-43

Interlock Register (Continued) 205/1205

RPI Missing Bit 2

The RPI Missing bit is set if the Run

Permissive input on the Resolver & Drive

I/O board is not on.

Hex Value: 0004H

Sug. Var. Name: IC_RPI@

Access: Read only

UDC Error Code: N/A

LED: N/A

Faults Need Reset Bit 3

The Faults Need Reset bit is set if previous

faults (register 202/1202) have not been

cleared.

Hex Value: 0008H

Sug. Var. Name: IC_FLT@

Access: Read only

UDC Error Code: N/A

LED: N/A

Rising Edge Required Bit 4

The Rising Edge Required bit is set if a

rising edge is not detected on a command

bit in register 100/1100.

Hex Value: 0010H

Sug. Var. Name: IC_RISE@

Access: Read only

UDC Error Code: N/A

LED: N/A

This interlock bit will be set if the application task has set the Fault Reset bit (register

100/1100, bit 8) but has not cleared and then re-enabled any command bits.

More Than One Request Bit 5

The More Than One Request bit is set if

more than one operating mode is requested

at a time in register 100/1100 (bits 0, 1, 2).

Hex Value: 0020H

Sug. Var. Name: IC_MORE@

Access: Read only

UDC Error Code: N/A

LED: N/A

Bus Not Ready Bit 6

The Bus Not Ready bit is set when turning

on the drive if the DC bus is not ready.

Hex Value: 0040H

Sug. Var. Name: IC_BUS@

Access: Read only

UDC Error Code: N/A

LED: N/A

The bus is ready when the DC bus voltage is greater than the undervoltage

threshold value stored in local tunable UVT_E0% and has reached a steady state,

and feedback indicates that the pre-charge contactor has closed.

This interlock bit will also be set when turning on the drive if the bus enable bit

(register 100/1100, bit 4) has not been set. Refer to the SA3100 Power Modules

instruction manual (S-3058) for more information about internal DC bus control.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 161 162

Commenti su questo manuale

Nessun commento

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuale Utente Pagina 81

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Rockwell-automation SA3100 Distributed Power System Drv Config,Program