Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuale Utente Scaricare il pdf (Pagina 14)

2-2

SA3100 Drive Configuration and Programming

Step 4. Select a product type and a regulator (control) type for both drive A and

drive B. See section 2.1.1 for regulator selection rules. The remainder of this

chapter assumes that you have selected an SA3100 Drive Product with a

Vector with Constant Power Regulator or Volts/Hertz Regulator.

Step 5. Select OK to add the UDC module to the rack and return to the Rack

Configuration screen.

Rules for Configuring/Selecting Drives for the UDC Module

The following drive configuration rules apply to all DPS systems:

1. The A and B drives do not both have to be used. You can configure only one.

2. Your A/B drive type combination is restricted only if you select an SD3000

(12-Pulse) drive, an SF3000 drive, or an SA3000 Parallel Inverters drive for either

drive A or drive B. For these products, you are restricted to the drive type

combinations shown in table 2.1. All other drive type combinations are allowed.

Figure 2.1 – Adding a UDC Module

Table 2.1 – Restricted Drive Type Combinations

If you choose for Drive A . . . Then your choices for Drive B are . . .

SD3000 12-Pulse Main SD3000 12-Pulse Auxiliary

SF3000

No PMI Attached

SD3000 (6-Pulse)

SF3000

SA3000 Parallel Inverters SA3000 Parallel Inverters Auxiliary

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 161 162

Nessun commento

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuale Utente Pagina 14