Rockwell-automation SB3000 Configuration and Programming Manuale Utente Scaricare il pdf (Pagina 55)

Configuring the UDC Module’s Registers

3-37

Interlock Register 205/1205

The Interlock tests are executed whenever bit 0 or bit 2 of register 100/1100 is set. The first problem

detected will cause the corresponding bit in the Interlock Register to set. If any of these bits are set, it will

prevent the voltage loop from running.

Configuration Parameters Not Loaded Bit 0

The Configuration Parameters Not Loaded

bit is set if the configuration parameters

have not been downloaded into the UDC

module from the Programming Executive or

if the parameters are outside of acceptable

limits.

Hex Value: 0001H

Sug. Var. Name: IC_CNF@

Access: Read only

UDC Error Code: N/A

LED: N/A

Gains Not Loaded Bit 1

The Gains Not Loaded bit is set if the

following pre-defined local tunables are zero

or if a UDC task containing these variables

has not been loaded to the PMI:

Hex Value: 0002H

Sug. Var. Name: IC_GAIN@

Access: Read only

UDC Error Code: N/A

LED: N/A

C_E6%GIT_E1%VDC_A% L_E6%IST_E1%VDC_FF%OVT_E0%VDC_KD%

UVT_E0%VDC_WCO%.

See Appendix B for a description of these variables.

RPI Missing Bit 2

The RPI Missing bit is set if the Run

Permissive input on the Rectifier’s Resolver

& Drive I/O module is not on.

Hex Value: 0004H

Sug. Var. Name: IC_RPI@

Access: Read only

UDC Error Code: N/A

LED: N/A

See register 201/1201, bit 0 for further information.

Faults Need Reset Bit 3

The Faults Need Reset bit is set if previous

faults (register 202/1202) have not been

cleared.

Hex Value: 0008H

Sug. Var. Name: IC_FLT@

Access: Read only

UDC Error Code: N/A

LED: N/A

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 121 122

Commenti su questo manuale

Nessun commento

Rockwell-automation SB3000 Configuration and Programming Manuale Utente Pagina 55

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Rockwell-automation SB3000 Configuration and Programming