Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuale Utente Scaricare il pdf (Pagina 37)

Basics of Programming the Drive Using the OIM

4-7

Step 4. If the existing value is shown, go to step 5. If you see a list of options:

a. Move the cursor to the option you want to select.

b. Press to accept the option.

c. Go to step 6.

Step 5. If you see the existing value:

a. Use and to move the cursor ( ) to the digit or sign (+ or -) that

needs to change.

b. Press or to change the number or sign. When changing the

numbers:

•

If the right-most digit is increased past 9, the digit to the left is increased

by one. Incrementing any other digit does not increase the digit to the

left. For example, if 19 is displayed, pressing changes the value

to 200. However, if 1 9 is displayed, pressing changes the value

to 109.

•

If the field is blank and you fill in the left-most digit, the digits to the right

are automatically filled in with zeros.

•

You cannot enter a number out of the parameter’s range. The drive

clamps values to a minimum or maximum.

•

Press to restore the previous value. You can then either change

the value or press again to exit the parameter entry screen

without accepting any changes.

•

Press to save the changed value. Go to step 6.

Step 6. Press to return to the list of parameters.

Step 7. Record changes to parameter values in Appendix C.

Figure 4.10 – Parameter Entry Screen with a List of Options

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 111 112

Nessun commento

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuale Utente Pagina 37