Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuale Utente Scaricare il pdf (Pagina 22)

3-2

GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0

3.1.2 Equipment Needed to Install or Replace the OIM

To install or replace the OIM, you will need:

•

OIM kit (M/N 2RK3000)

•

Drill with 5.0 mm drill bit

•

#1 Phillips-head screwdriver

•

Strain relief for serial cable

3.1.3 Installing the OIM

To install the OIM:

Step 1. Disconnect power from the drive.

Step 2. Select the mounting location. The mounting location should be:

•

within 5 meters (16.4 ft.) of the drive

•

at eye level

•

easily accessible

Step 3. At the desired mounting location, drill two 5.0 mm holes and cut out the

opening in the enclosure door. Refer to figure 3.1 for enclosure cutout

dimensions.

ATTENTION:

Do not install or remove modification kits with power

applied to the drive. Disconnect and lock out incoming power before

attempting such installation or removal. Failure to observe this

precaution could result in severe bodily injury or loss of life.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 111 112

Nessun commento

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuale Utente Pagina 22