Rockwell-automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE Manuale Utente Scaricare il pdf (Pagina 21)

1785-6.5.19 November 1998

Installing the Interface Module 2-5

Installing the Interface Module To install the PLC-5 Ethernet Interface Module, you must:

• attach the connector header to the processor

• attach adhesive washers to the processor

• connect the interface module to the processor

• install the combination into the chassis

Attach the Connector Header to the Processor

If you have not already done so, attach a grounding wrist strap to your

wrist. Then follow these steps to attach the connector header to the

processor:

ATTENTION: If your power supply is already

installed in the chassis, be sure the chassis power supply

is turned OFF before you begin the installation

procedures. Do not attempt to install the interface

module with chassis power ON. Installing the module

with chassis power ON will damage the module.

Attach the interface module to

this end of the connector header.

Locate the PLC-5 processor

connector header port.

Push the exposed pins into the

holes on the PLC-5 processor.

20596±M

1. 2.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 53 54

Nessun commento

Rockwell-automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE Manuale Utente Pagina 21