Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manuale Utente Scaricare il pdf (Pagina 21)

Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012 21

Chapter

Add the POINT I/O Ethernet Adapter and Digital Output Module to

an RSLogix 5000 Project

In this chapter, you complete the following tasks:

• Add the 1734-AENT Ethernet adapter to the RSLogix 5000 project

• Add the 1734-OB4E digital output module to the RSLogix 5000 project

• Use ladder logic to test the 1734-OB4E digital output module’s lights

Before You Begin

You must complete these tasks before using this chapter:

• The tasks described in Before Using This Publication on page 5, including:

– Prepare the Logix5000 control system hardware

– Prepare the computer

– Configure the networks

– Create an RSLogix 5000 project

The example RSLogix 5000 project used in this chapter uses a

CompactLogix 5370 L3 controller.

• These tasks described in Chapter 1, Prepare the Distributed POINT I/O Module

Hardware on page 13:

– Mount and Connect the 1734-AENT Ethernet Adapter

– Mount the 1734-OB4E Digital Output Module

– Mount and Wire the 1794-PS3 Power Supply

– Wire the 1734-AENT Ethernet Adapter to the Power Supply

• Verify that the 1734-AENT POINT I/O Ethernet adapter’s thumbwheel switches are set

to a valid IP address, as described on page 16

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Nessun commento

Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manuale Utente Pagina 21