Rockwell-automation 61C501 AutoMax/AutoMate 115V Input Module Manuale Utente Scaricare il pdf (Pagina 11)

3Ć1

 

This section describes how to install and remove the module and its

cable assembly.

 

The installation of wiring should conform to all applicable codes.

To reduce the possibility of electrical noise interfering with the proper

operation of the control system, exercise care when installing the

wiring from the system to the external devices. For detailed

recommendations refer to IEEE 518.

  

Use the following procedure to install the module:

Step 1. Turn off power to the system. All power to the rack as well

as all power to the wiring leading to the module should be

off.

Step 2. Mount the terminal strip (M/N 57C370, 61C505, or

61C506) on a panel. The terminal strip should be mounted

to permit easy access to the screw terminals. Make certain

that the terminal strip is close enough to the rack so that

the cable reaches between the terminal strip and the

module.

Step 3. Fasten field wires to the terminal strip. Typical field

connections for 115 V AC inputs are shown in figure 3.1.

Refer to Appendix C for the arrangement of terminal board

connections. Make certain that all field wires are securely

fastened.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Nessun commento

Rockwell-automation 61C501 AutoMax/AutoMate 115V Input Module Manuale Utente Pagina 11