
12 12 Input/12 Output Discrete Embedded TTL I/O Module with Pulse Width Modulation and DeviceLogix
Publication 1799-IN008A-EN-P - July 2005
Refer to the following table for the word/bit definitions for the 1799-12G12GL
boards
Configure Module Parameters
The module has 11 parameters that are configurable through a DeviceNet software
configuration tool such as RSNetWorx for DeviceNet. The DeviceNet configuration
tool requires an electronic data sheet (EDS) to configure the module’s parameters.
You can find the EDS file on the ODVA Web site (www.odva.org).
Use the descriptions in the following table to help you configure the parameters.
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Produced 0 I7 I6 I5 I4 I3 I2 I1 I0
Produced 1 Reserved Logic Enabled Reserved Reserved I11 I10 I9 I8
Produced 2 O7
PWM Enabled 1
O6 05 04 O3
PWM Enabled 0
O2 O1 O0
Produced 3 O15
PWM Enabled 3
O14 O13 O12 O11
PWM Enabled 2
O10 09 O8
Produced 4 NetOut 7 NetOut 6 NetOut 5 NetOut 4 NetOut 3 NetOut 2 NetOut 1 NetOut 0
Produced 5 NetOut 15 NetOut 14 NetOut 13 NetOut 12 NetOut 11 NetOut 10 NetOut 9 NetOut 8
Consumed 0 O7 O6 O5 O4 O3 O2 O1 O0
Consumed 1 O15 O14 O13 O12 O11 O10 O9 O8
Consumed 2 PWM 7 PWM 6 PWM 5 PWM 5 PWM 4 PWM 3 PWM 2 PWM 1
Where: I = Input; O = Output; PWM = Pulse Width Modulation
PWM 0 through 7 = Pulse Width Modulation percent value
Parameter Description
AutoBaud Enables the board to match the network’s data rate. When
enabled, Baud Rate parameter is ignored.
Input Off-to-On Filter Time Controls the amount of time the input must be in the on
state before the board reports the input as on.
Input On-to-Off Filter Time Controls the amount of time the input must be in the off
state before the board reports the input as off.
Output Idle State Controls the state of each output when the DeviceNet
master is in an idle state.
Output Fault State Controls the state of each output when the board loses
communication with the DeviceNet master.
Output Idle Value Controls the value that outputs will have when the output
idle state is set to use idle value.
Commenti su questo manuale