
Analog Output Module 7
0(& /&+* /+"-
To set the last state configuration jumpers,
proceed as follows.
!
ATTENTION
Do not insert modules
into or remove modules
from the I/O chassis
while system power is
ON. Failure to observe
this rule could result in
damage to module
circuitry and unexpected
machine operation.
4) ) ) )
4) ) ) )
4
4
4
These output conditions are active only if
the following conditions exist:
• the module faults
• the processor is in the PROGRAM or
TEST mode
• rack switch 1 is in the reset position
+ /" /%" (./ .//" +*#&$0-/&+* '0),"-. +0 !+ *+/ *""! /+
-")+1" /%" )+!0(" +1"-
./ //" 0/,0/ "1"(
+*#&$0-/&+* 0),"-.
-+*/ +# &- 0&/ +-!
+, &"2
-"#0((3 -",+.&/&+* /%" '0),"- /+ -"#(" / /%" !".&-"! 1(0". &*
/%" /(" /+ /%" ("#/
-"#0((3 ,0(( 0, +* /%" '0),"- /+ -")+1" &/ #-+) /%" ,&*.
Commenti su questo manuale