Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manuale Utente Scaricare il pdf (Pagina 11)

Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011 11

Chapter

Quick Start Guide

The Quick Start Guide will give basic instructions on how to use your new RFID

ICODE handheld interface.

Powering up the RFID

ICODE Handheld Interface

1. Charge the unit for a minimum of three hours prior to first use.

a. If you are using the wall charger and serial cable (57RF-HH-56IN,

57RF-HH-56US2):

i. Plug the power jack of the battery charger/power supply into the

corresponding cable connector as shown below.

Figure 1 - Power Jack

ii. Remove the rubber cover from the RS-232 connector on the bottom

of the RFID ICODE handheld interface. Plug the interface cable

into the connector.

iii. Plug the battery charger/power supply into a power outlet. The

Charge LED should turn on, indicating that the batteries are

charging.

Figure 2 - Power Outlet

b. If you are using the charging cradle (57RF-HH-56US1):

i. Plug the two-pin connector of the power supply into the back of the

charging cradle as shown below.

Figure 3 - Charging Cradle/Power Supply

Power Supply/Battery Charger

To Unit

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 111 112

Nessun commento

Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manuale Utente Pagina 11